1 / 2
Clip on cape remix for Lucky 13 — image 1
1 / 2

Clip on cape remix for Lucky 13

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A cape remix you can clip onto Lucky 13.

Rating
0 / 5
Likes
46
Downloads
172
Makes
0
Views
821
Reviews
0

Updated at source:

Model information

Category
Sculptures
License
Creative Commons — Attribution

This is a remix of the “cape for batman” by Minerva712 to clip on Lucky13.

Two cape sizes… a 35% scale which is just down to the waste and a 45%x45%x50%L cape which extends past the buttocks.

Print the cape on shoulders with the clip on the plate.  Support from plate to get the shoulder curve.  It is very thin so you may want to change the “top contact z distance” to .2 so the supports don't over bond to the thin cape.

I only printed it in PETG which worked great for the socket and cape.  .2 layer.  I did not try PLA.

I also remix'd Lucky's 00a02-armature-neck.stl with a third ball and used the clip off of 00a01-armature-head.stl to add the clip to the cape.

Including the two clips I used to bond to the cape in case you would like to do your own.

I bonded a 3UDC clip (3UDC_Clip-Shaft_side-clip_TOP_print-top-down_with-lift-hook.st) on the slicer plate to the 00d02-display-base-joint.stl so I could mount it on a 10DLR display rail using a 10DLR_3UDC_12mm-w-key_NO-rumble.stl key.  That will allow me to attach it to the display rails I have in my office.