Ceiling Fan Remote Holster Model UC7225T
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a wall mounted holster / holder for a ceiling fan remote control.
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 71
- Makes
- 1
- Views
- 362
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a ceiling fan remote holster for model UC7225T. My fan is a Hampton Bay model but perhaps this remote is included with other fans. You can operate the buttons without removing it from the holder.
The remote is about 46mm x 22mm x 150mm, and the holder goes up to the bottom set of buttons, about 56mm. There was a curve on the remote, so while the holster conforms to that curve, there are flat strips on the back to allow it to sit flush with a wall. There are also #6 ANSI countersunk screw holes for attaching to the wall, or you could use double sided tape or Magic Release adhesives on the flat parts.
I did not need supports. I built a 45 degree angle under the top flat spot so that there is no unprintable overhang.
This was built in OnShape, and the CAD is available here.