1 / 3
Spray Can Wall Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder for common spray cans - spray paint, WD-40, brake cleaner, etc.
- Rating
- 4.5 / 5
- Likes
- 59
- Downloads
- 344
- Makes
- 3
- Views
- 1,312
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
NEW VERSION HERE
Details:
- Holds a single spray can at 50 degrees from the wall
- Designed to have the bottom of the can above rest on the attachment part
- Counter-bored holes that will allow for a 1" (25 mm) screw to be used into ¾" (18mm) plywood without the screw piercing through (YMMV if you have too much elephants foot).
Printing:
- Recommend using 10% infill and gyroid
- Recommend using zero (0) top/bottom layers
- Print “top” down on the bed of your printer (meaning the 50 degree angle will be fully supported with no overhang)
- PLA is fine, PETG would probably be better (haven't printed in it though)
Following this will reduce the amount of filament needed to print, and is functionally and strength-wise equivalent to having top/bottom layers.