WeAct RP2040 Case
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.33 – €0.40 net (excluding VAT)
For file: WeAct RP2040 Case_0.2mm_PETG_NEPTUNE2S.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.36 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 24 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is case designed for RP2040 from WeAct Studio (alternative to Raspberry Pi Pico)
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 89
- Makes
- 0
- Views
- 914
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This case specifically designed for RP2040 module from WeAct Studio.
This is bit snug fit (extra 0.30 mm length and width applied to original datasheet specifications) and before printing make sure that z-seam is aligned properly. Else blobs might come in a way. Use of a sand paper at some place might help. For me I had no issue.
Check out the images for the PCB dimension and case dimensions.
Print Guide:
Material: PLA, PLA+, PETG (I used Overture RED) or any other works
Layer Height: 0.2 to 0.24