Amaryllis Support Ring V2
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.46 – €3.01 net (excluding VAT)
For file: AmarylisSptV2_PETG.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.73 excluding VAT (range midpoint).
- Weight reported by the author
- 22 g
- Print time reported by the author
- 3.39 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
V2 (updated Feb23) A support for Amaryllis flowers
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 22
- Makes
- 0
- Views
- 648
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A simple one-piece ring support for Amaryllis flowers. Note: this support needs to be added as the flower spikes grow (before flowers open. The ring is 60mm int dia and can accommodate 3+ flower spikes. It is designed to be used with 3.5mm wooden kebab skewers (which act as the legs). Works best with the 4 legs splayed out to the edge of the pot (which braces the ring against the weight of the flower spikes nicely). All internal surfaces are fully rounded to avoid hard edge pressure points on the stems. Prints inverted in PETG (V2 Update: Feb23) - prints inverted, requires no support [240/85 first then 250/90]. V2 has finer lines, uses less filament and is stronger.
Oversized wooden kebab skewers may need to be shaved back a little.