Pegboard Pliers Holder (25mm holespacing - 4.5mm hole)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These holders are Fast printing with minimal filament. Made to be used with 10mm square wooden dowels.
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 25
- Makes
- 1
- Views
- 367
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
These hooks or holders are printed flat and with minimal filament needed.
The most stress is on where the hook meets the vertical piece. But because of the printing orientation, the layer lines run perpendicular to the vertical piece, giving it more strength. It was printed in PETG too, giving this puny hook more strength than you'd give it credit.
I put a dab of superglue to connect the hooks to the wooden dowels (10mm, square) and I was surprised by the result. Give it a try!
These were printed with a 0.6mm nozzle like most of my printing. My layer height was 0.24.