Number keycaps

Number keycaps for Cherry MX/Gateron switches

Keyboard Used: Keychron K4 (100 key/96%)
Supported Switches: Cherry MX and Gateron

I had a lot of fun making the arrow keycaps and wanted to keep going. Ended up making some keycaps to replace the ones on my number pad. 

Please feel free to remix this as you please. All I ask is that you give me credit as the original creator. Also, if you end up printing this, please share some photos of it and let me know what you think!

Arrow Keycaps: https://www.printables.com/model/398755-arrow-keycaps

---
Print Settings

Everything was printed with a 0.4mm nozzle, 0.12mm layer height, 15% infill at 125mm/s on an AnkerMake M5. No supports or brims are needed. Each of the .stl's are oriented properly and should be ready to be sliced and printed.

Adhesion Issues?
Try printing with a 8-10mm brim. 

Quality Issues?
Try printing at a slower speed (start decreasing the speed by 10-15mm/s). The stem could get messy if it’s printed really fast.

---
Part List

There are two main parts, the “[number]-top.stl” and the “key-bottom.stl”. To help make printing easier, the “0-9 Tops.stl” and “[10x] key-bottom.stl” can be used so you only have to slice two files.

Separate STLs

• 0-top.stl
• 1-top.stl
• 2-top.stl
• 3-top.stl
• 4-top.stl
• 5-top.stl
• 6-top.stl
• 7-top.stl
• 8-top.stl
• 9-top.stl
• key-bottom.stl

Combined STLs

• 0-9 Tops.stl
• [10] key-bottom.stl

---
Filament Used

---
Instructions

1. Print the parts
2. Put [number]-top.stl on top of key-bottom.stl and push down until it slides in. Be careful not to put all of the force on the stem.
3. Put finished keycaps on your keyboard.