1 / 10
Basic Shower head
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Print Settings : [ Supports : Yes ] [ Filament : ABS, PETG ] [ Resolution : 0.12 ] [ Infill : Gyroid 10% ]
- Rating
- 3.5 / 5
- Likes
- 51
- Downloads
- 348
- Makes
- 3
- Views
- 1,898
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
NEW MODEL WAS FIXED
- If you use hot water, ABS/PETG is required - water temperature is below 80 degrees Celsius.
- If printing with PLA, the water temperature is below 55 degrees C.
- Do not put support inside the handle tube
- Best print at layer height = 0.12mm
- Just wrap with thread sealing tape, washers are not really necessary
Notes:
Cooling when printing ABS at 50%