MA-03074 / 001303074 Lamborghini LP400, Miura, Islero, Espada Fuel Tank Filter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The in-tank "Salva" brand fuel filter of a number of classic Lamborghinis (and possibly Ferraris)
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 272
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
The in-tank "Salva" brand fuel filter of a number of classic Lamborghinis (and possibly Ferraris) is utterly NLA, or in the hundreds of dollars. The sensible thing to do when refurbishing a fuel tank is probably to use a modern push-on filter sock, BUT this was created for those who want to explore using an OEM-like substitute.
Presented here is an un-tested (also never 3d printed) version based on an actual pulled part, and information referenced here:
http://www.miuraworkshop.com/GTTav7FuelTank.html http://www.miuraworkshop.com/tav29.html http://www.huskyclub.com/tav29.html
This untested design is meant to be printed in Nylon, or some other fuel resistant plastic. It's a 3 piece design with both ends snapping into a main body that needs it's plastic windowss removed with an xacto in order to expose an expected #100 stainless steel wire fuel mesh of an expected thickness of around 0.22mm sized as an about 70mm x 42-46mm sheet to roll up and put inside the filter body (held in by the snap-in ends). The inner DIA of the available are for the SS mesh is about 12mm, so 37.7mm circumference - hence a little extra for overlap.
I think I've left enough room and created support for one layer (and a short overlap) of the mesh in the tubes/snap-in ends clearance, but that is untested. (I have no 3D printer to test this).
Remember, this is an untested/unprinted thing. Try at your own experimentation risk. Please leave some feedback if you try it, and find the model needs improvement.
Category: Automotive