Fully Printable Parachute for Toy Soldier
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fully printable parachute for toy soldier. Vase mode for lower weight. No glue needed.
- Rating
- 0 / 5
- Likes
- 85
- Downloads
- 395
- Makes
- 1
- Views
- 3,678
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Share Alike
Fully printable parachute for toy soldier. Vase mode for lower weight. No glue needed. The model consists of three parts, which is printed separately. I printed it on MINI+ with 0,4mm nozzle and PLA.
Print info
Main body needs to be printed in VASE mode with just one bottom layer (because of weight).
Rope needs to be printed with 100% infill (4x).
Backpack can be printed with default configuration.
Material: PLA
Nozzle: 0,4mm
Layer: 0,2mm
Supports: NO
Print time: 2h 8m
Weight: 17g
Assembly
One end of the rope needs to be pushed inside hole on backpack and other end to parachute. Maybe it can be little difficult to push rope inside a backpack, because of lower tolerance. In this case you should use pliers to push it inside carefully, but then it will hold up inside well. On the parachute is higher tolerance of hole, so there is no problem to push it in. In case of crash it will disconnect instead of breaking it.
To achieve a successful drop, let it go from higher height.
Thank you for downloading and like.
