Mini-Ware-Logo
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
MiniWare Logo to emboss it into your TS100/101/80 case for example
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 93
- Makes
- 1
- Views
- 366
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A recreation of the MiniWare Logo. It's just an approximation I drew from a picture, so it might not be accurate.
The box shown as example is from https://www.printables.com/model/345083-rugged-multipart-pinecilts100ts80-case-v2 that was also the motivation to recreate the logo analog to the pinecil logo present in the orginal files. The file was scaled to a width of 100mm and used as negative volume on the box lid and as a seperate body to be printed. It was then glued into the recessed area. Luckily there was no additional tolerance adjustement needed.