Raspberry Pi Header Cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a snap-on cap for the standard Raspberry Pi header. Helps avoid damage when storing or running without a case.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 29
- Makes
- 0
- Views
- 170
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a snap-on cap for the standard Raspberry Pi header in case you want to run the pi naked but worry about something shorting all those easy-to-drop-stuff-on header pins. Sure you could just cut off an old connector or print something with a buncha holes. But then you gotta line up all the pins and printing a buncha holes can be a pain. This just snaps in place over top of the whole assembly. Has little cutouts on either side for clearance in case you have a baseplate screwed onto the bottom.
This is an actual-dimensions file - meaning it's not scaled to compensate for material shrink or a poorly calibrated printer. You'll need to scale accordingly if those are issues for ya.
Edit: I just realized the original cap won't work with the Zero or the 3B+. Created and posted a new version with a notch cut out so it'll work.
Print Settings
Printer Brand:
LulzBot
Printer:
Mini
Rafts:
No
Supports:
No
Resolution:
I went with 0.2mm
Infill:
I did 50% but anything will do
Notes:
Prints clean and quickly. As mentioned in the description this is an actual-dimensions file that is not scaled to compensate for any material shrink or poor printer calibration.
Category: Electronics