Electribe 2 and Electribe Sample angled voronoi stand (no foam)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This custom voronoi stand is made to keep the Korg Electribe Sample (or Electribe 2) propped up at a nice 12 deg angle…
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 73
- Makes
- 0
- Views
- 939
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
These files are for Personal Use Only. If you would like a Commercial License to sell prints made from these designs, please join me on Patreon: https://www.patreon.com/kazitoad
This custom voronoi stand is made to keep the Korg Electribe Sample (or Electribe 2) propped up at a nice 12 deg angle and look good while doing it.
One of the supports has an integrated cable holder for the power cable and some headphones. The left-side support has a cutout to access the SD card and USB port and the back is completely open to allow for cable access. I wanted to limit the number of supports but I realized that they would block the bottom facing LEDs, so that led to a beefier design than imagined.
If you would like to replicate this stand you should print 3x supports, 4x spacers, right and left side STLs. To assemble all you have to do is skewer the pieces with 2x M4 threaded rods of 360mm length and cap them with nuts and washers. This design is somewhat modular so it could be used for a number of other synths of various dimension.
This version of the design does not incorporate the laser-cut foam (as pictured) but I might update this if people want the foam version.
Enjoy :)