Magnet holder for Papermate Inkjoy pen (single, parametric)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Used to hold a Papermate Inkjoy pen on the refrigerator using the power of magnets!
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 97
- Makes
- 5
- Views
- 533
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
I designed a holder for a Papermate Inkjoy pen as they are my partner's preferred pen and we use them to write things on the calendar on our fridge. I dislike rummaging through the utensil drawer next to the fridge to find the pen, so I designed a holder that will stick to the fridge. I left enough space inside for the pen tip to be able to be left in the extended position, just in case someone forgets to retract it before storing it.
I used a pair of 6x2mm neodymium magnets that I had ordered in bulk for Gridfinity bases. The OpenSCAD model is parameterized so that the magnet size can be changed if you have another size on hand. Initially, I just pressure fit the magnets into the holder but I've found they really should be superglued in place for long term use. The model could also be adapted for a different size pen if you're not a fan of the Inkjoys.
I also designed a dual pen version which can be found here.
The model in the photos was printed in EurekaTec PLA Cyan with 0.2mm layers, with supports and a brim since there isn't a lot of contact with the base plate. Printing with the hole down leaves a nice finish on the visible parts and the only places that should have supports are the magnet holes. The center is a very short bridge that should be doable on most printers so it shouldn't need a support.