Arduino Water rocket stuff
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Water rocket parts with arduino to trigger parachute and to send information (height, acceleration, ..) to a base unit.
- Rating
- 0 / 5
- Likes
- 40
- Downloads
- 108
- Makes
- 0
- Views
- 2,318
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Hi,
some time ago we took water rockets quite seriously and designed several stuff for it.
The rocket had a small sender, sending information about the flight to the “station” (ground control) at my son. It also controlled the deployment of the parachute depending on either: leaving top height, orientation, …or time.
I am sure, noone will build this according to the files here again in the exact same way (no water rockertry does) and also noone will use the same arduino code, but I think the parts itself (parachute deployment top, wings and parts of the launch pad) will be very helpfull for some of you. …That is why I post them here.
For the starter: you should use as “bike” valve to prevent water from running down the line… This comes on the rocket side. The other side takes a FESTO air connector.
I am sorry for not sharing arduino code - I used some libraries and code snippets where I am unsure of the distribution license. To avoid conflict, I will not share…
However, I am very happy to help! If you have issues with the parts, I can adapt them for you or support with additional advice.