Shark Rocket Vacuum Wall Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple wall holder for Shark Rocket vacuum.
- Rating
- 5 / 5
- Likes
- 48
- Downloads
- 546
- Makes
- 2
- Views
- 3,065
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Simple wall holder for Shark Rocket vacuum. Using Command Strips to attach to the wall.
Make sure that vacuum is not completely hanging in the air on this holder. Command Strips will not hold it forever. Adjust holder height so that the bottom of the vacuum is standing on the floor.
I printed it with PETG but could be anything else, including PLA.
I would suggest at least 25% infill.
No support and no raft are required.
UPDATE:
Added new part - brush head stop.
The vacuum is heavy enough to slightly pull the velcro on the hook from the wall. So, I added a brush head stop - a small step on the floor. Used sticky tape to attach it to the floor.
Printed it (stop) in PLA, vertically on its side to make it a bit stronger. Used brim.