608 Bearing Feline Fidget Spinner
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
finally...a fidget spinner for your cat
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 76
- Makes
- 1
- Views
- 686
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial
Don't let the lack of fingers and opposable thumbs deny your cat from all the fun.
Now your kitty has a fidget spinner all their own
Assembled model measures 82mm tall x 180mm wide (3.2” x 7.08”)
a 608 skate bearing is required - these can be purchased for as low as $4 for a pack of ten on Amazon or eBay.
a steel bearing is recommended, as they perform better than a 3D printed bearing, if you decide to print the bearing, I recommend using Ultimate 608 Bearing with Calibration Kit V2 by Matvey Kukuy
Print settings
To provide sufficient weight, 100% infill is recommended for the base and spheres , the remaining parts can be printed at 20%
supports are required for the spheres
printed parts:
- cap
- spinner
- spheres (x2)
- pin
- rod
- base
additional items needed:
- 608 bearing
- CA glue (super glue)
assembly:
Holes are sized roughly .6mm larger than the rods and threaded ends of the spinner to compensate for print anomalies - gluing is required
- insert rod into base with the end with the hole facing up.
- insert the pin into the rod
- press the 608 bearing into the spinner
- screw the spheres onto the spinner
- place the spinner on the pin
- glue the cap onto the pin

