Vine Vase

My wife bought 2 plastic hanging vines for our bedroom but I wasn't sure how to hang them up. That's why I designed a small vase for them.

You simply screw it to the wall/cupboard then slide the stem of the top of the vine inside and let it hang down.

Tip: If you have open windows and the vine gets blown by the wind it could tilt sideways. Do Not overtighten the screw as this could snap the vase. Instead I would suggest putting double sided tape on the flat part on the back of the vine vase before screwing it to the wall/cupboard.

Do you want to be able to sell any or ALL of my prints shown here on Printables.com?
If so, then click on the 'buy me a coffee' link below, (or click here) and join one of my memberships. This gives you the option of a monthly, yearly or lifetime commercial license, along with a certificate and loyalty bonus models (both commercial and non-commercial). The non-commercial items are 3rd party models that may also interest you, all in one place.
The lifetime membership offers you unique commercial items not available to anyone else as well as all of the loyalty bonus models.

Please click the LIKE (Heart) Button if you like my models. If you REALLY like them, then please also buy me a coffee at the bottom of the page. Thank you.

Printing Instructions:

I printed these on my Creality CR-6 SE printer with Cura slicer 5.2.1. (Other printers/slicers can be used).

Material: PLA

Manufacturer: Prima Value

Colour: Light Grey

Resolution: 0.2

Nozzle: 0.4mm

Print Speed: 80mm/s

Nozzle Temperature: 210 Degrees

Bed Temperature: 60 Degrees

Infill: 10%

Supports: No

Skirt: No

Brim: No

Raft: Yes

You can try various orientations on the print bed but I printed mine upright as is and used a raft to make sure it didn't wobble or fall over.

Enjoy your prints.

                           https://www.buymeacoffee.com/tigertone