1 / 3
F1 Logo Coaster w/ Inlay
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made a simple coaster with F1 logo and an Inlay if wanted.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 91
- Makes
- 0
- Views
- 400
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
F1 coaster made in time for the upcoming season. Printed in PETG could be done in PLA if not going to be used outside. The inlay has been sized to 98.8% to fit into the recess. I used a small hammer and piece of flat plastic to tap in the inlay with a small drop of CA glue underneath.
They look absolutely amazing if you put a thin layer of art resin epoxy over top.
After printing the coaster I would print the test file to make sure it fits and adjust size percentage as necessary.
