Prusa MK2S, MK2.5, MK2.5S Z-Axis Reinforcement/Brace
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
With the introduction of the new Prusa MK3(S) frame, I wanted to make my MK2.5S similarly rigid, if not more so.
- Rating
- 4.5 / 5
- Likes
- 12
- Downloads
- 84
- Makes
- 2
- Views
- 996
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
With the introduction of the new Prusa MK3(S) frame, I wanted to make my MK2.5S similarly rigid, if not more so. There were a couple great options, such as this:
https://www.thingiverse.com/thing:1656945
This design and others came with two issues. Firstly, they all required complete disassembly of the Y-axis. And secondly, even if I did use one of their designs, the setup wouldn't work with this Y-axis upgrade I'm planning to install:
https://www.thingiverse.com/thing:2836470
This solves both problems by being a drop-in solution; no Y-axis disassembly required. And it really does make the entire frame stiffer.
Other than the printed parts you will need:
Two 14.5" lengths of 5/16" threaded rod
Eight 5/16" nuts
Six 5/16" washers
Four M3x20 screws
Four M3 nuts
Optional: Plastic tubing with 5/16" ID
Print instructions
I personally used the following settings: PETG, 5 perimeters, 20% cubic infill, and 0.2mm layer height. You can use any filament, as long as it's fairly stiff after printing. I had some Proto Pasta CFPLA in my bin, but that seemed a little overkill at the time.
Print as oriented in the files for the stiffest part