Anycubic Mega Pro Laser Alingment Jig
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An alignment jig for repeatably aligning blanks and jigs for the use of the laser feature of the Anycubic Mega Pro.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 45
- Makes
- 0
- Views
- 593
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I was tinkering with my laser attachment for my Mega Pro after finding this tutorial for using it with LightBurn. I needed a way to align my blanks and jigs in a repeatable way for engraving; thus, this model was born! Just align the lip with the corner of your bed and attach it with some 19mm wide binder clips and you should be ready for some freaking lasers!
Printer Settings:
Layer Height: 0.2mm
Adaptive Layer Height: Yes
Infil: 25%
Orientation: Lip facing up
I didn't find supports to be necessary but your mileage may vary.
Print time on my Mega Pro was roughly an hour and a half at 60mm/s with PLA.
Installation Instructions:
I recommend using these steps to install the jig: (All movements were done using the LightBurn move menu)
- Install the laser on your Mega Pro using something square to align it with the bed
- Attach the printer to your computer with a USB
- Zero the printer
- Raise the Z-axis to 50mm
- Move the bed out for easier access
- Install the alignment tool
- Finally, click the “Go to Origin” button
You are now ready to engrave! The very corner of the alignment jig should be (0, 0) within LightBurn.