XYZ test cube 20 mm in FilaFlex40
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My first test print with FilaFlex40 after 2x failed phone case prints. Successful with brim, X-nozzle and max.
- Rating
- 4 / 5
- Likes
- 6
- Downloads
- 146
- Makes
- 1
- Views
- 1,007
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial
My first test print with FilaFlex40 after 2x failed phone case prints. Successful with brim, X-nozzle and max. 20 mm/s speed anywhere.
Print instructions
The nice cube printed in FilaFlex40 from Filatech. It´s quite chalenging filament. It failed the first time after detaching from the table close to the end. With the brim it went flowless. I have changed the speed to 20 mm/s max everywhere. Anything else standard Prusa. The nozzle is X-nozzle with 0.4 mm diameter. I didn´t find much information about the setting for the applied filament. And the standard settings didn´t work fine.