1 / 4
Phone Wedge Stand - 17 mm - Vase Mode
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Larger Version of the "phone wedge" by Catdad Workshop
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 91
- Makes
- 2
- Views
- 403
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
I found the phone wedge by Catdad Workshop and really liked the clean, simple design. I downloaded it, printed it, and the largest size was just too small for my S22 Ultra with a very thick case.
So, I grabbed the STL, increased the opening to 17 mm, and now it fits even this large phone and case perfectly! It's still very stable.
These are the print settings from the original model, and I used everything, except I stuck with 0.2mm layer height:
Print settings
- Layer height: 0.3mm - (I used 0.2, but the original designer suggests 0.3)
- Line width: 0.8mm (this helps to make it sturdy, you can set this even on a 0.4mm nozzle)
- Bottom layers: 0 (you don't need a bottom!)
- Printing temperature: bump it up 5 to 10 degrees higher than usual
Notes
The model in the photos was printed in Voxel PLA+ on an FLSun Super Racer with a 0.4mm nozzle.