1 / 6
Arca-Swiss grip for telephoto lens — image 1
1 / 6

Arca-Swiss grip for telephoto lens

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

From doing a lot of shooting with a long, heavy lens, I wanted to be able to support the weight further out than the…

Rating
0 / 5
Likes
14
Downloads
74
Makes
0
Views
1,327
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

From doing a lot of shooting with a long, heavy lens, I wanted to be able to support the weight further out than the tripod mount/grip allowed. I'd been using a 200mm Arca-Swiss style quick release plate for this purpose, but it was a little uncomfortable, so I created this: smoother, fits in palm, keeps the wrist at a more comfortable angle. The improvement is significant, especially that far towards the front of the lens, though it does make tweaking focus a lot harder ;-)

Original design was in one piece, but this meant the grooves that engage the QR plate needed support and thus a lot of cleaning, so I broke it into two pieces with the grooves now facing up - join with epoxy or cyanoacrylate. Ideally, the fit should be snug enough not to slip off the end, which may take some sizing adjustments or filing, especially since aftermarket Arca-Swiss style plates can vary by a few tenths of a millimeter.

EDIT 08/25: Tweaked the base design with rounded edges, and included a "-Test" version of each to print out and check against your plate - there's a lot of variation in the sizes from aftermarket manufacturers, so test it first to save yourself some time.

EDIT 09/26: Due to finding no glues that hold long or well enough, I did a version that requires no glue and is held together with a peg, but I have not yet printed this version. Look for the parts labeled "noglue."

The Tamron 150-600 G2 version already has the Arca-Swiss grooves engraved into the tripod mount, but it's slightly wider above the grooves than below, so I made another base plate to accommodate this (TelephotoSupport-BaseWider.stl). You only need two pieces, so if you're mounting to a standard AS plate as shown in the photos, you won't need this.

IMPORTANT: This isn't intended to be used as a carrying handle and shouldn't be allowed to hold the entire weight of the lens - I can't vouch for the material strength. Used as shown, it shouldn't be stressed anywhere near enough to break.

Print Settings

Printer Brand:

Printrbot

Printer: 

Printrbot Simple Metal

Rafts:

No

Supports: 

No

Resolution:

0.2mm

Infill: 

15%

Filament: ESun PLA+ Black

 

 

 

Category: Camera

Tags