Walksnail 1s lite nano mount adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a push fit ring for the walksnail 1s lite camera. It gives you mounting holes for nano camera mounts/canopies.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 221
- Makes
- 0
- Views
- 1,551
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Public Domain
Print in tpu, and press fit over the knurled focus tightening ring with the tabs facing towards the camera pcb (this will space the canopy out nicely for the mobula6 hdzero canopy)
Should weigh 0.15g when printed in tpu95a
Be sure to fit this soon after printing - once the TPU cools it will harden a bit and be quite tough to fit over the lens. If this happens you can heat up the TPU with a hair dryer for a few minutes to get it soft and pliable again.
I also added the spacer tubes i used to fit the Walksnail VTX in the Mobula6 frame at just the right height when using my build https://rotorbuilds.com/build/31524 - print out 5 of these (i used PLA+, PLA would be fine too, or even TPU in a pinch, and one of them can be cut down to 1mm height to use under the rear post on the top side so that the canopy doesn't push down on the Arterytek processor. I used PLA because the VTX does not need soft mounting. Hard mounting may actually be better as it wont move around.