Fossil Watch Wall Mounted Charging Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This wall-mounted charging stand allows you to charge and keep your Fossil Smartwatch out of the way, while still…
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 66
- Makes
- 0
- Views
- 735
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Men
- License
- Creative Commons — Attribution — Noncommercial
This wall-mounted charging stand allows you to charge and keep your Fossil Smartwatch out of the way, while still being easy to access.
Included is a Fusion 360 file. There, you can adjust these parameters:
The dimensions of the screw hole to fit whatever screws you're using
The offset of the dovetail joint. The default is what worked for me at a .28mm layer height, yours will likely be smaller.
If you like this model, please feel free to support me at
https://www.buymeacoffee.com/JoshuaA
Installation instructions (coincides with pictures)
Note - I'm having troubles getting the order correct, the order of the photos seems to be reversed. Nevertheless, installation should be pretty straightforward
Screw the wallplate into the wall first, and make sure the holes are aligned.
-Back out the screw a little bit on one side, and all the way on the other side, so you're able to slide the charger cable into the groove on the back. Partially screw back in the screw that was fully unscrewed-Clip in the charger holder into the dovetail joint.
-Put the charger itself into the space in the charger holder, then pull the remaining cable from the bottom until all of the cables nestle nicely in the grooves.
-Finally, screw back in both screws all the way so the wall mount is flush against the wall.
Print instructions
Category: Gadgets Summary
This wall-mounted charging stand allows you to charge and keep your Fossil Smartwatch out of the way, while still being easy to access.
Included is a Fusion 360 file. There, you can adjust these parameters:
The dimensions of the screw hole to fit whatever screws you're using
The offset of the dovetail joint. The default is what worked for me at a .28mm layer height, yours will likely be smaller.
If you like this model, please feel free to support me at
https://www.buymeacoffee.com/JoshuaA
Installation instructions (coincides with pictures)
Note - I'm having troubles getting the order correct, the order of the photos seems to be reversed. Nevertheless, installation should be pretty straightforward
Screw the wallplate into the wall first, and make sure the holes are aligned.
-Back out the screw a little bit on one side, and all the way on the other side, so you're able to slide the charger cable into the groove on the back. Partially screw back in the screw that was fully unscrewed-Clip in the charger holder into the dovetail joint.
-Put the charger itself into the space in the charger holder, then pull the remaining cable from the bottom until all of the cables nestle nicely in the grooves.
-Finally, screw back in both screws all the way so the wall mount is flush against the wall.
Print Settings
Printer Brand: Creality
Printer: Ender 3
Rafts: No
Supports: No