1 / 3
Solder Fume Extractor
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This build contains a bit of perfboard, some LEDs, and of course a 120mm fan with a carbon filter.
- Rating
- 5 / 5
- Likes
- 58
- Downloads
- 130
- Makes
- 0
- Views
- 1,889
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Check out the build video on YouTube! https://www.youtube.com/shorts/HjpijkvjOJA
Prints without supports; I used PETG. Built with parts I had on hand, here are links for your convenience:
- 120 mm fan (I used a Noctua NF-P12, but any should do): https://www.amazon.com/gp/product/B07CG2PGVG
- Panel mount barrel jacks (2.1 mm): https://www.amazon.com/dp/B091PS6XQ4
- 3-pin screw terminals: https://www.amazon.com/gp/product/B07RLJQWNZ
- 2-pin screw terminals: https://www.amazon.com/gp/product/B07NSJV6NW
- Perfboard: https://www.amazon.com/gp/product/B079DN31SW
- Nuts/bolts (M4, M2): https://www.amazon.com/gp/product/B07S1R8NL7
- Don't use the specific LED strips I used, they have a terrible CRI! Anything 12V should work, just cut to fit. The LED track is 10 mm wide.
Note the LED wiring can block the lower bolt holes, so you'll either need to move the wires to the side to fit a bolt through, and/or get a bit creative with the assembly order.