Borescope Mount for Hangtight Duct
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Recently started seeing people post about using USB borescopes to watch the nozzle lay down the first layer (or watch the thing work its magic remotely). Figured I'd whip up something simple to hold the one I had handy. The hole is 5.8mm diameter.
Two STLs are available:
The mount block itself so you can adjust it for best position before gluing to Hangtight's duct.
The block attached to the duct to print as one piece. The geometry I used to make the hole is centered on the nozzle tip.
My scope had other plans and needed adjustment of the block for a good view so I didn't reprint the duct.
Original design: https://www.thingiverse.com/thing:3594559
Print instructions
Category: 3D Printer Accessories Summary
Recently started seeing people post about using USB borescopes to watch the nozzle lay down the first layer (or watch the thing work its magic remotely). Figured I'd whip up something simple to hold the one I had handy. The hole is 5.8mm diameter.
Two STLs are available:
The mount block itself so you can adjust it for best position before gluing to Hangtight's duct.
The block attached to the duct to print as one piece. The geometry I used to make the hole is centered on the nozzle tip.
My scope had other plans and needed adjustment of the block for a good view so I didn't reprint the duct.