Sovol SV06 Fanduct 2.0
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fanduct for SV06 with decreased distance of air outlet to nozzle.
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 118
- Makes
- 1
- Views
- 1,686
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Previously I uploaded a remixed fanduct for the SV06. After testing I found that the air outlets were to far away from the nozzle. Which is why I designed my own Fanduct.
It still uses a regular 40-20 fan and you will lose approx. 3mm in x-direction as it will home at the blower casing.
It works like a charm!
For the setup (as with my initial upload) you will need:
Standart 40-20 Blower 24V and JST 1,25 connector
4x M3x20mm Screw (NO Flathead)
3x M3x20mm Flatheadscrews
3x M3 heat inserts with a low profile (I used ruthex M3 short, availabl from the big A).
Printer settings:
You can print all parts without supports
0.4 Nozzle
4 perimeters
5 top and bottom layers
Heat resistant material (eg. Extrudr Greentec Pro)
Assambly:
Heatsink the inserts into the pockets within the groove of the blower. Take care not to push to far.
After that, place the fan into the groove and wire the cables through the mounting plate hole. Place the mounting plate sothat the holes are lining up and use the M3 Flatheadscrews to marry mounting plate and Fanduct.
Mount the plate to the back of the X-sled with the 4 M3x20 screws.