Swedish Folding Ruler Marking Gauge
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.38 – €1.68 net (excluding VAT)
For file: Swedish Folding Ruler Marking Gauge_0.6n_0.2mm_PETG_MK3S_1h33m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.53 excluding VAT (range midpoint).
- Weight reported by the author
- 20 g
- Print time reported by the author
- 1.55 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This variant of the common version supports swedish rulers, like Hultafors brand and such
- Rating
- 5 / 5
- Likes
- 51
- Downloads
- 232
- Makes
- 3
- Views
- 1,033
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Variant of VolkerMueller's variant of the folding ruler marking gauge. This one fits our swedish common types, such as Hultafors brand, which are 17mm wide.
(gap is 17.7x7 mm compared to VolkerMueller which is 16.6x8.4 mm).
Also I added some fillets to the surrounding frame, and on the bottom shaft hole, to make it less promiment for problems with “elephant foot syndrome”.
Model consists of three solids. They print-in-place. Make sure to use 0.2 mm layer height otherwise the gaps become wrong. It requires a little effort to make lever loose, just be tough but gentle on it and massage it a little back and forth when it is released and it is done.
Printing instructions
- Layer height 0.2 mm (important!)
- Material PETG or something sturdier could be a good idea.
- Supports could be a good idea as well. But only on build plate and on the gap where ruler lies (paint support tool).
- To make it sturdier, beef up perimeters to four
- Personally I changed infill to 20% rectilinear. But that might be overkill.
- Also, I added ironing on all top surfaces, not necessary but it gets nicer.
- Included G-codes are with these modifications. I use 0.6 mm nozzle but I have included both 0.6 and 0.4