1 / 2
Coaxial power connector splitter case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Casing for female coaxial power connector/barel jack connector.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 28
- Makes
- 0
- Views
- 231
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Model is used as casing/housing for female coaxial power connector/barel jack connector (panel mount type). On one side of the housing there is hole for connector mentioned above (diameter 8 mm). On other side of the housing there is squared opening for cables - for two pairs as casing is meant to be used as splitter.
Print settings:
- Layer: 0.2 mm
- Brim: recommended
- Supports: no
Assembly instructions:
- Remove brim from all parts. Clean cable cutout on cap part (there is one full layer for better bridging)
- Solder 2 pairs of wire to female connector (use heatshrink for isolation if needed). Mount female connector to body part.
3. Glue cap part to body part.
Updates:
22.03.2023
- Initial release
- Body_V1, Cap_V1