Amiga 1200 Custom Trapdoor remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I wanted a tighter fit on my own A1200 as when I printed the original part in Formfutura White ABSpro it fit ok, but…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 98
- Makes
- 0
- Views
- 482
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
I wanted a tighter fit on my own A1200 as when I printed the original part in Formfutura White ABSpro it fit ok, but there was a bit of movement and rattle. Perhaps there is some shrinkage on the ABS that causes this, if printing with PLA you might be better off with the old part.
I used Blender to increase the size on this.
This new part is a fraction larger to allow for shrinkage, dimensions of old and new part below:
New Dimensions:
168.957mm
82.59mm
10.978mm
Old Dimensions:
167.75mm
82mm
10.9mm
Print instructions
Category: Computer Summary
I used Blender to increase the size on this.
This new part is a fraction larger to allow for shrinkage, dimensions of old and new part below:
New Dimensions:
168.957mm
82.59mm
10.978mm
Old Dimensions:
167.75mm
82mm
10.9mm
Print Settings
Rafts: No
Supports: Yes
Resolution: 0.1
Infill: 90
Notes:
It printed well for me at 0.1mm and 90 percent infill on my Ultimaker 2 Extended. I used 90 percent infill as there seemed to be a big print time difference between 90 and 100 percent.
I used supports on both ends of the trapdoor to allow the clips to print without turning into a mess.
Post-Printing
Some light sanding on the clips on both ends to smooth them out a bit. 5 mins work at most.