Multi D-Link DGS-108 switch holder
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.52 – €1.86 net (excluding VAT)
For file: Holder2-1_0.3mm_PLA_MK3S_1h25m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.69 excluding VAT (range midpoint).
- Weight reported by the author
- 27 g
- Print time reported by the author
- 1.41 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Multi D-Link DGS-108 switch holder
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 21
- Makes
- 0
- Views
- 259
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Multi D-Link DGS-108 switch holder.
We use several stacks of the named D-Link DGS-108 switches in some laboratories and they use to look messy when they are stacked on each other because the tend to slide around…
This little holder should keep them from sliding around. =)
The holder is available to secure 2, 3 and 4 switches in place.
You will need between 4 and 12 M5x20 screws to mount the holder depending on the amount of switches you want to hold in place.
Printing instructions:
- 0.3 draft profile.
- Textured sheet used for the outside parts to look nicer.
- Steel sheet used for the connector parts, because they are not really visible in the end.
- No brim needed
- No supports needed.
Happy printing =)