1 / 1
Wall Anchor
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Just in case you need to anchor down.
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 223
- Makes
- 0
- Views
- 828
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
One day I decided I needed to make an anchor for a friend. This is that anchor.
Prints in one piece. Finish it to look metallic and it's actually pretty convincing. Rustoleum hammer finish paints are a good choice to get that texture. Rub-n-buff for the highlights over top the hammer finish.
Be careful scaling it down, you may run into issues on a few of the chain supports or make the wall mount on the back too small. Better perhaps to cut it up in PrusaSlicer and print in parts if necessary.