Action Army AAP01 (airsoft) retractable stock

This is a remix from https://www.thingiverse.com/thing:4660187 base model to be able to support a retractable stock.

I cannot find a free stock model for app-01 that is retractable that I like. So, I remix from a model that I like to fit my style.

This is not a print & play model. Post-processing is required.

Additional parts list:

2x 10mm thin wall aluminum tube. (I use tubes from a cheap shoe rack)

2x M3x4mm screw (For stock release)

2x M3x14mm screw with nuts (For attaching butt plate into the tube)

2x 7x10mm spring or longer (For stock release)

other than these (screws to attach the stock to the gun) will be the same as the model from https://www.thingiverse.com/thing:4660187

Assembly:

-Screw M3x4mm screw into stock release and place a spring on top of it.

-Fit aluminum tubes into the butt plate.

-Drill a 3mm hole through the tube where a hole on the butt plate should be and screw M3x14 to secure it.

-Put an assembled stock release on both sides of the stock and put the assembled butt plate through the stock release and holes on the stock.

-Mark the tube where a screw on the stock release should be. (Put it on the length you are comfortable with)

-Drill a 3mm hole on the mark.

-Try it on and see if it locks.

-Finished!

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.28

Infill:

Filament: Maxwork Filament PLA

Notes:

Category: Sport & Outdoors