Bosch oven hanger
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A better oven hanger that rotates with the oven so it prevents stuff from falling off.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 92
- Makes
- 0
- Views
- 534
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Open Community License v1
I designed these hangers for our oven so that when you open it, the things attached to them don't fall out. The hanger works by having the hook on a hinge which gets rotated by the weight of the attached thing. Therefore when you open the oven door, the hook rotates down keeping stuff still attached.
Printing instructions
Print all parts at 0.2mm layer height or lower, at 0.3mm the holes could be too small. Other than that you can do pretty much anything with the settings.
Second version assembly
The assembly is very simple and all you need to have is a piece of 1,75mm filament to act as a hinge. Just put it through the left hole of the whole part, slide it through the hook and push it through the right hole. The right hole is intentionally smaller so that the 1.75mm filament piece doesn't fall out of it.
First version assembly (in case someone still wants to use the old version)
The model is split into 3 parts:
1) This is the part that will be placed on the oven handle. It's dimensions are set exactly so that it doesn't fall of but still is easy to put on the oven.
2a) This is the part which is connected to the first part by a piece of filament which will also serve as the axis on which it will rotate.
2b) This serves as the hook where you will put your kitchen tools.
The assembly is very simple and all you need to have is a piece of 1,75mm filament that fits inside the hole in the part 2a and you also need a bit of super glue.
After printing take the 2a part and with a bit of superglue on the flat piece sticking out of it insert it into the 2b part's hole. Make sure you place it in the correct orientation (The hook must face away from the hole where you place the filament). After that is done all you have to do is place the 2a+2b parts between the holes of part 1 and insert the filament through all of the holes. Then you can just place it on the oven handle and it's ready to use.