Voron 2.4R2 Z Belt Covers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modded Z Belt Covers based upon Akio's design but keeping the V2.4 BOM.
- Rating
- 5 / 5
- Likes
- 61
- Downloads
- 679
- Makes
- 12
- Views
- 2,541
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- GNU General Public License v3.0
These covers allow for hidden cable routing for wires going up the Z Extrusions, they also have a cutout in case you didn't leave enough room under the Z Rails(most people don't :P).
In case you want to add some extra pop to your covers, you can swap colors between layers 3 and 4, which is enough to look good on the top, but would make only the top surface a smooth looking piece, while you'd have a pretty noticeable color difference when looking at the sides.
To remedy this you can either color change between layers 4 and 5, leaving a single line on your covers, OR preferrably change the filament after doing the bridging section on layer 4.
Pictures courtesy of jmaurin#7720, over at the Voron Discord.