Filamentspoolholder on Voron 2.4 using Prusa org. Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A re-routing of filament through "Bowden Guide with 360° Print-in-Place Joint" the rolls required higher position.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 0
- Views
- 434
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A re-routing of filament through "" the rolls required higher position.
As I still had my org. Prusa filament rolls holder I just needed to design a block fitting on the 20x20 Voron 2.4 profile and the Prusa roll holder fitting my design.
Here I post this result. Fits perfectly and solved my problem. In case of a filament runout sensor I just put this between upper PTFE tube and rolls. Don't need the sensor that often. Another advantage is that I don't need to fiddle with filament behind the large V2.4-350. That'll work!
Printed on my Voron 2.4 with red PETG. 3 hexscrews M3 and M3-T-nuts made the installation easy.
Note: design is laid out for a 3mm Acrylic top plate. 4mm top plates may require some small intervention.
PS: Here is the Bowden Guide with 360° Print-in-Place Joint: https://www.printables.com/de/model/301503-bowden-guide-with-360deg-print-in-place-joint/comments/752314