Nikon deep lenshood HB-32

Another remix of laurent_despeyroux's deep lenshood, this time to fit everything that Nikon's HB-32 lens hood fits: 18-140mm f/3.5-5.6G ED VR, 18-105mm f/3.5-5.6G ED VR, 18-135mm f/3.5-5.6G IF-ED, and 18-70mm f/3.5-4.5G IF-ED.

Used the bayonet mount from mitch_vg's hood, tweaked slightly.

Should be fine straight off the print bed, but some light sanding might be needed for a good fit, and/or shortening the tabs slightly to fit nice and level - I extended them a little after testing but did not reprint a new one (I do not have this lens handy to keep testing.)

Doesn't hurt to print the bottom ring and stop it to do a test - adjust in slicer if necessary.

EDIT 06/23: Modified a version for a different lens, so included a modified version here too, with thicker walls - that's ‘HB32RemixThikr.stl’

Print Settings

Printer:

Voxelab Aquila

Rafts: 

No

Supports:

No

Resolution: 

.2

Infill:

At least 15%

Filament:

eSun PLA+ 

Black

Notes:

Test print of the mount is recommended before spending all the time printing the entire hood. Other than that, should be a breeze. Spray painting the interior surface with matte black is a good idea, but even light sanding will eliminate shine

Category: Camera