1 / 2
Stand for 7" x 9 1/4" Speaker
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stand to lift a speaker by 144mm from whatever you set it on.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 50
- Makes
- 0
- Views
- 384
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Share Alike
This is a stand that I made for one of my rear surround sound speakers. The stand will lift a speaker exactly 144mm from whatever you set it on.
The stand is made of 4 interlocking pieces. I recommend gluing the top and bottom.
Print with a minimum of 4 walls for strength. 15% infill should be sufficient.
The base should be printed upside down to avoid supports.
Both pieces of the center portion should be printed on their side. I used supports on the center portion, but they were minimal and from the base plate only.