Four relay board mounting plate - single and double
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made for Arduino projects - four channel relay board mounting plate prepared for threaded inserts - single and double
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 85
- Makes
- 0
- Views
- 344
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Made for Arduino projects - in mine case I needed to put relay board upside down to bottom of railway set. This is for four channel relay board mouting plate and prepared for threaded inserts. These can be pushed in with a solder iron. If you're feeling lucky, you could also use some tiny screws without inserts. There are also side “ears” with mouting holes, so you can actually first bolt down the relay board and then mount the whole completed set.
My relay board has this pattern of four corner holes - horizontal spacing 66,2 mm and vertical spacing 47mm, so check that first or go to my original model on onshape.com and modify it to your specific needs:
https://cad.onshape.com/documents/281d382eba2249e7887ad55c/w/52a07a68c2c857cb0431fea5/e/269ceac5b2b3fb452c1f1b33
Recomended threaded insert: 2,5x3-5mm
Recomended bolt: 2,5x3-5mm
There is single and double configuration available.