Skadis Mount Voltcraft VC135 Multimeter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Skadis Mount for a Multimeter from Voltcraft (VC135)
- Rating
- 4.75 / 5
- Likes
- 20
- Downloads
- 166
- Makes
- 4
- Views
- 670
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
modeled from scratch, but highly inspired by https://www.printables.com/model/361590-multimeter-halter-voltcraft-ikea-skadis - so all credits to him.
Since this is my first upload, I hope the category is the correct one.
I printed the original version first, without really paying attention to the correct model of the multimeter in the picture - of course, it didn't fit, cause I had one version bigger.
I searched a bit if there is any mount for this particular model out there, without success, so I decided to create my own. Since I am very bad with altering existing models, I decided to create a "new" one, but closely follow the design patterns of the original
One thing I wanted to improve were the hooks, and my actual first prototype came out perfectly, so I decided to keep it as it is.
Print settings I used and recommend (I printed in PLA because I thought I'd need to print multiple more, but I strongly suggest PETG for anything pegboard related)
Layer Height: 0.2mm (probably works with 0.3 as well, but didn't test)
Perimeters: 3
Infill 30% - I think 20% is sufficient, but wouldn't go lower.
Supports: everywhere (for the hooks)
Print time around 4h
Since it's my first upload, any feedback will be appreciated even more than usual :)