PCB Standoff
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.50 – €0.61 net (excluding VAT)
For file: standoff-1_02mm_pla_mk3s_41m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.55 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 41.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A standoff to mount a small electronic circuit board (PCB) on a mechanical carrier board, such as plywood.
- Rating
- 0 / 5
- Likes
- 31
- Downloads
- 318
- Makes
- 0
- Views
- 3,348
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- GNU General Public License v3.0
A standoff to mount a small electronic circuit board (PCB) on a mechanical carrier board, such as plywood.
The standoff clips into a hole in the board. A screw goes through its top that keeps the PCB in place. If the screw is long enough to
reach into the standoff's foot, it spreads the foot apart, and anchors the standoff firmly on the board. If you expect only light loads, you can use short screws. The standoff holds fairly well on its own.
Many aspects of the standoff are parameterized. The tested dimensions are:
Height above the board: 5 mm
Screw diameter: 2.2 mm
Total length: 17 mm
Hole diameter: 6 mm
board thickness: 4 mm
Problems:
- The standoff splits lengthwise when the screw is tightened firmly.
- Insertion forces are fairly high, pliers are usually necessary.
Print instructions
The batch of 10 standoffs does not need a brim, however a single standoff needs a brim.
No supports are needed.
The side with the slim plastic strips is down. The strips provide contact surface with the platter, so that you don't need a brim. Additionally they hold the batch together, to keep you organized.