Picture Hanger (Sawtooth)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I like to do my own framing of printed photos, but the frames often lack a good mounting point. This 3D printed part…
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 307
- Makes
- 1
- Views
- 1,118
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution
I like to do my own framing of printed photos, but the frames often lack a good mounting point. This 3D printed part adheres to the back of the frame. For lighter frames, I've been using high strength 3M mounting tape (3M Scotch Extreme Mounting Tape, 1 inch wide). For heavier frames I suggest glue, such as cyanoacrylate or hot melt (my favorite!).
For the wall I use WallDriller drywall anchors, although about anything will work.
Nothing special about printing this, 50% fill, .15 to .2 mm layer, support enabled.
Enjoy!
Category: 2D Art