Steam ControllerJoystick cap (PETG/PLA)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cap used to replace the rubber part of a Steam Controller joystick
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 33
- Makes
- 0
- Views
- 369
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial
YOU NEED TO REMOVE THE RUBBER FROM THE JOYSTICK TO BE ABLE TO PUT THE CAP
The rubber in the joystick was sticky and all worn out, I first saw a model by Vcom but it was not suitable to be printed with any hard materials, only TPU which I did not have at the moment, I printed using PETG and fuzzy layers in cura to give it some texture, in case you want to use my exact same settings for the fuzzy skin those were:
- Fuzzy Skin Thickness: 0.1mm
- Fuzzy Skin Density: 3.0
Print with the orientation AS-IS and with supports in the bottom as that part is not visible anyway. You'll need to apply a little bit of force to insert it, but it's a snug fit and does not wobble from my experience.