1 / 13
Gearbox powered Flying-Toy (1:32 gear ratio; mostly printed only) — image 1
1 / 13

Gearbox powered Flying-Toy (1:32 gear ratio; mostly printed only)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

One rotation of the drive_knob to release the rotor to the ceiling.

Rating
0 / 5
Likes
8
Downloads
49
Makes
0
Views
693
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

UPDATE:

  • uploaded an improved rotor with much better flying performance and easier to print (printed it with 0.2mm layer height and tree support)

**Important Notes:

  • i do not recommend this for 3D print beginners
  • you have to use silicone spray to make the gearbox work properly
  • i have not done long term testing - so far it works like a charm
  • all gears should be printed with 0.1mm layer hight and the teeth have to be 100% clean
  • during assembly, make sure that every single gear can rotate without any resistance
  • to make the gears rotate easily, rotate them 2-3 times, deassemble them and clean the touching surfaces - repeat until no more resistance is noticeable
  • see .stl info field for quantities
  • you'll need 5x cylinderhead screws M3x8mm + 4x M3 nuts (make sure, no screw will block any adjacent part)

I've printed all the gears with 0.1mm layer height PLA 200°/60° and normal support.

All casing parts and the drive_knob are printed with 0.2mm layer height.

For the rotor i had best results with printing 0.1mm layer height and tree support.

I'm still working on improving the rotor and will upload further variants later.

 

See pictures for printing orientation.

 

 

Tags