Assemble after print - Cascade card wallet with levers on both side remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cascade card wallet with levers on both side to dispense half the card stack
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 150
- Makes
- 0
- Views
- 1,659
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE 2026/07/02: Consider this instead:
I find the original a bit tight/tough to dispense all cards in the stack, also there's not enough space to identify and pick a card. My solution, dispense half the stack on one side. I have to model this from the ground up to apply my improvements/changes, taking the original look and design as reference. This model is about 4mm shorter than the original
Thanks to the original designer and all the remixers.
Print in PETG for the best wear-resistance and flex.
Parts for 6 or 8 cards provided. Parts prints flat with no support needed.
For 6 cards: 1x body6, 2x button6, 2x fan3, 2x lever6-xxx
For 8 cards: 1x body8, 2x button8, 2x fan4, 2x lever8-xxx
Dry fit parts, sand/file if necessary before press fitting. Use c-clamp when pressing button and lever if necessary.
When using, fans can/will collide, use cards to push them to slide in place.
Enjoy!