Folding Collapsing Katana Scabbard Attachment
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A scabbard attachment for michtill's Folding Collapsing Katana in Thingiverse, designed for small printers.
- Rating
- 0 / 5
- Likes
- 34
- Downloads
- 124
- Makes
- 0
- Views
- 3,812
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution
A scabbard attachment for the michtill's Folding Collapsing Katana in Thingiverse. It uses 3D Printy's Spring Latch to connect each scabbard piece.
Due to the print size of my Ender 2 Pro, I was only able to print my katana in 70% scale, hence I was only able to test the scabbard in 70% scale. I'll include 2 separate folders for the 70% and 100% scales.
Snap Latches for Scale 70
The Snap Latches for the Scale 70 pieces uses M2x6mm screws.
Snap Latches for Scale 100
The Snap Latches for the Scale 100 pieces uses M3x8mm screws.
Scabbard Lid
This part locks and connects directly with the lock of the katana. When connected to the katana, the katana may wobble a bit since it only locks on one side.
Scabbard Belt
This is a variation of the Scabbard piece that has attachment points on the sides to place snap latches to connect with the Belt Attachment piece. Expect that the scabbard will hang 30 degrees from the horizontal.
Belt Attachment
This piece will hang your scabbard on your belt. It has an opening of 47mm x 6mm. Each folder has their respective Belt Attachment piece for the proper size snap latch.