Opener for Ceres Chill
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.64 – €2.01 net (excluding VAT)
For file: CeresChillOpener v1_0.2mm_PLA_MK3S_2h4m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.83 excluding VAT (range midpoint).
- Weight reported by the author
- 18 g
- Print time reported by the author
- 2.06 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A tool to help unscrew the Ceres Chill when stuck.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 52
- Makes
- 1
- Views
- 668
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Share Alike
The connector of the Ceres Chill can seal very firmly to the bottle after being chilled. This tool rests over the connector, allowing you to twist it more easily.
I have included a slight taper to the tool head. This should help the tool drop into place, and should allow it to work even if your printers tolerances are off by up to .4mm or so. YMMV - post if you have issues.
Printing:
I used the stock print settings for my nozzle, plus ironing to provide a nicer finish. No supports are needed. Stresses are along the layer lines and the geometry is simple, so bumping filament temperature and increasing perimeters will result in a stronger print with no real downsides. I don't think it's necessary, though I haven't tested it to failure :).
I printed in PLA, you may want to use PETG to avoid deformation in case the tool is left in a hot car.