1 / 5
BlueSpark mounting bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounting bracket for BlueSpark Tuning box
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 17
- Makes
- 0
- Views
- 269
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
Simple mounting bracket for BlueSpark Tuning module, to keep it secure and bolted in place.
Instructions below for fitting for a Kia Picanto GT, where I've mounted on the top of plastic fuse box cover, however can use the bracket to act as a guide for other positions, cars etc.
Required parts
- 2x Bracket
- 1x Hole Template
- 4x M3 x 12mm Cap Head Screw
- 4x M3 nylock nuts
Printing notes
- Materials
- Brackets - ASA, Nylon, etc due to being located under a warm bonnet.
- Hole Template - Anything
- Perimeters - 4
- Supports - off (brackets designed to be printed as orientated)
- Infill - 20%
Fitting instructions
- Use hole template to drill holes in fuse cover.
- Note orientation of text, otherwise mounting will be at 90 degrees, and cables may not reach.
- Place template hard against spare fuse storage on inside to get a good position.
- Use the guide to position the holes so screws won't cover text of the fuse guide.
- Drill holes using 3mm bit.
- Fitting of brackets
- Undo the adjustment end of the tuning module using torx bit.
- Slide on the brackets with cut areas facing each other. (Cut back area on top is to allow full exposure of BlueSpark logo)
- Secure the adjustment end back in place.
- Mounting of tuning module
- Use M3 screw to pre-locate nylocks into brackets
- Orientate with cable clip to Front of fuse box.
- Mount tuning module through pre-drilled holes, using M3x12mm Cap heads.
- Clip fuse box back into car, clip in cables, enjoy the extra horsepower!